I just installed this on the weekend
I made the stud from a m10-1.5 bolt, I made the flange offset by .06 to match the hole and countersink on the compound. It wont spin and was a light press fit.
This page preserves a discussion thread from the original AirgunWarriors.com community forum, reproduced here as originally written. If you're a contributor to this thread and would like something removed or credited differently, contact info@airgunguide.com.
This thread originally included member-uploaded photos. They were hosted externally and are no longer available, so they've been omitted below.
Good job. Thank you for posting. More set up options.