I've had the original wedge-brake on the cocking pin for several years, and it worked just fine, but it has finally failed. I can't seem to find another, or any alternative. Looking for suggestions.
This page preserves a discussion thread from the original AirgunWarriors.com community forum, reproduced here as originally written. If you're a contributor to this thread and would like something removed or credited differently, contact info@airgunguide.com.
This thread originally included member-uploaded photos. They were hosted externally and are no longer available, so they've been omitted below.
Try contacting Steve in NC I'm pretty sure he had something for the QB's
On all my QB's I've wound up using a short still spring under zero preload.
Archer Air guns had an anti bounce devise of some kind for 78 series guns.
Haven't seen those things in years..seem to have evaporated..last to sell them was Archer's.
A good number of posts/tests about 10 years back.
Really simple "U" design(with thicker "legs" than the curve)..rebonding hammer would jam the thicker legs against the pin slot..basically a friction brake.
It worked reasonably well with factory rough pin slots....didn't work with well polished pin slot....and it tended to self-polish with use.
Had the elegance of simplicity.
Yes, that is exactly what I had, but after years of flawless operation, it finally failed. It just basically wore thru where it contacted the cocking slot sides, and ceased to function. I'd love to find another one, or for that matter, any other solution to hammer bounce in a QB.
I have Steve's free-flight hammer devices in 3 of my Snowpeak/Diana CO2 guns, and they work very well. I just need to do something with my QB.
Have you tried a simple twin spring system? (self explanatory)
Tags
QB77 · QB78 · QB79 · Hammer Debounce · Parts Source